Skip to content

Legacy Hardware

OLED codes

OLED Error Codes

Here is a guide for troubleshooting the error codes that may be displayed on the front panel OLEDĀ of certain legacy machines:

  • GpuGetDriver: Failed to read GPU driver version
  • GpuDet: Failed to detect GPU
  • GpuGetFw: Failed to read GPU firmware
  • SyncDet: Failed to detect sync card
  • SyncGetFw: Failed to read sync card firmware
  • SyncGetState: Failed to read sync/display sync state
  • SyncSetState: Failed to setup sync/display sync state
  • SyncClrState: Failed to clear sync/display sync state
  • SyncGetRate: Failed to read incoming sync signal
  • ConnEnum: Failed to enumerate physical outputs
  • ConnGetDisp[0-5]: Failed to find physical output number for display
  • ConnDetEdid[0-5]: Failed to detect edid state of output
  • ConnGetEdid[0-5]: Failed to read edid from output
  • ConnSetEdid[0-5]: Failed to emulate edid for output
  • ConnClrEdid[0-5]: Failed to remove edid from output
  • DispEnum: Failed to enumerate displays
  • DispGetMode: Failed to read display mode
  • DispGetRate: Failed to read display refresh rate
  • DispGetBit: Failed to read display bit depth
  • DispGetCol: Failed to read display colour subsampling
  • DispSetMode: Failed to set display mode
  • DispSetRate: Failed to set display refresh rate
  • DispSetBit: Failed to set display bit depth
  • DispSetCol: Failed to set display colour subsampling
  • DispGetOrder: Failed to read display ordering
  • DispSetOrder: Failed to order display
  • DispSetExtend: Failed to extend display
  • DispSetEnable: Failed to enable display